EVA Suit

A Rear entry suit and skin suit

Since the atmospheric pressure on Mars is near vacuum, the settlers will need Space Suits for external operations, such as EVA or surface exploration. Certain areas in the settlements may also be kept at low pressure and require pressure suits. During some periods of the transit to Mars, notably take off and landing, it may be required to wear pressure suits in case of accidental loss of pressure. __

Design requirements

EVA suits

This suit provides protection from vacuum, temperature and radiation. It includes telecommunications and autonomous life support.

Life support
- Air pressure: Most space suit designs use a design pressure of 4-5 psi, or about 1/3 of normal atmospheric pressure. They use an atmosphere enriched in oxygen to provide sufficient oxygen to the astronauts.

When changing from normal atmosphere to the lower pressure of the space suit, an adaptation time of 3/4 hours to one hour is required to avoid the risk of decompression sickness (the bends).

- Temperature control
- CO2 management
Dust protection
Radiation protection

Pressure suits

These would be similar to the suits worn by astronauts during launch, or high altitude pilots. Services such as cooling, air, communications and power would be done through an umbilical connection, to simplify the design and reduce the mass of the suit. These normally operate within a pressurized atmosphere, but offer safety in case of accidental decompression.

Emergency pressure suits

These might be simplified versions of pressure suits, designed to be worn in case of accidental pressure loss in part of an habitat. Their main purpose would be to allow occupants to reach areas of safety through pressurized air locks in the habitats. Proper habitat design, in particular dividing habitats into sectors each provided with independent life support systems and connected by airlocks might make such suits redundant. Designing habitats to be 'blowout' resistant would also mitigate the need for this type of pressure suit.

Type of suits

Suitport on a rover

Prebreathing period

In the US space shuttle, cabin pressure was reduced from normal atmospheric to 70kPa (equivalent to an altitude of about 3000m) for 24 hours before EVA, and after donning the suit, a pre-breathing period of 45 minutes on pure oxygen before decompressing to the EMU working pressure of 30kPa. In the ISS there is no cabin pressure reduction, instead a 4 hour oxygen pre-breathe at normal cabin pressure is used to desaturate nitrogen to an acceptable level. US studies show that a rapid decompression from 101kPa to 55kPa has an acceptable risk, and Russian studies show that direct decompression from 101kPa to 40kPa after 30 minutes of oxygen pre-breathing, roughly the time required for pre-EVA suit checks, is acceptable.[1]

How to put on a suit

The Russian Orlan spacesuit is entered through the rear, with the backpack acting as a door, whereas the American EMU has various seals at the waist, the helmet, the gloves, the boots, etc. The Russian system can be entered in only five minutes, and with one seal is considerably safer as well.

The rear entry suit can be used with a suitport. This can reduce contamination of the habitat by preventing any ingress of exterior dust.

Pressurized vs. Skintight

All spacesuits used to date have been pressurized, i.e. filled with air. It can be difficult to move in these suits, and as such they are only pressurized to a third of normal pressure to allow easy movement. To adapt to this low pressure and avoid the risk of nitrogen narcosis an adaptation period is required. This requires the person who will be executing the EVA to breath pure oxygen for a few hours to purge their body of nitrogen, or to reside for up to 45 hours in a gradually lowered atmospheric pressure. This is time consuming and not practical if an emergency EVA were to be carried out.
An alternative could be a skintight suit, the Mechanical Counterpressure suit, like the biosuit ^[1]. However, these suits are difficult to enter and exit. At this time, they are also planned to use a pressure of 4-5 psi, and therefore they do not reduce the adaptation time or solve the emergency exit issue.

Researchers at MIT are working on a spandex and nylon BioSuit to be used in such a situation. The torso would be pressurized to about 30 kPa while the limbs would be sheathed in thinner material allowing for increased dexterity and decreased weight from the current model. ^[1]
Rigid suits at full atmospheric pressure have also been researched.